Calculated Industries 4065 v3.1 User Guide - Manual (Page 92)

84 — C
ONSTRUCTION
M
ASTER
® P
RO
/ T
RIG
/ D
ESKTOP
(Cont’d)
PREFERENCE OPTIONS
3) Volume Display Format – *Standard (if units entered are the
same — e.g., Feet x Feet x Feet — the
answer will remain in this format (cu. ft),
but if units entered are different — e.g.,
Feet x Feet x Inches — vol. answer will
always be displayed in Cubic Yards)
– Cubic Yards (vol. answers always
displayed in Cubic Yards, regardless of
unit entry — e.g., Feet x Feet x Feet =
Cubic Yards)
– Cubic Feet (vol. answers always dis-
played in Cubic Feet, regardless of unit
entry — e.g., Inches x Inches x Inches =
Cubic Feet)
– Cubic Meters (vol. answers always
displayed in Cubic Meters, regardless of
unit entry — e.g., Feet x Feet x Feet =
Cubic Meters)
4) Stairwell—Headroom – *6 Feet 8 Inch (default)
Height – Use + or – key to increase or
decrease above value by 1 Inch
5) Rake-Wall Descending – *Descending (Rake-Wall studs are
or Ascending displayed from largest to smallest size)
– Ascending (Rake-Wall studs are
displayed from smallest to largest size)
6) Arched Wall Outside – *Outside (Arched walls are calculated
or Inside for outside of the arc)
– Inside (Arched walls are calculated
for inside of the arc)
7) Jack Rafters Descending – *Descending (Jack rafters are
or Ascending
displayed from largest to smallest size)
– Ascending (Jack rafters are displayed
from smallest to largest size)
(Cont’d)