Brandmotion 9002-1010 - Manual (Page 4)

INSTALLATION
INSTRUCTIONS
1010 Instructions 9-30-14.doc 4 of 8
Install Supplied Mirror
27. Remove upper mirror wire cover from vehicle mirror,
(Figure 12). Note: wire covers will not be reused.
Figure 12
28. Use a T20 Torx Bit to loosen the screw that secures
the mirror and carefully slide mirror upward to
remove. (Figure 13)
Figure 13
29. Remove the 10-pin mirror connector from back of
vehicle mirror.
30. Open sunglass storage compartment of vehicle
overhead console to gain access to the rear edge of
the center panel and gently release the retaining
clips of the center panel. (Figure 14)
Figure 14
31. Use a T10 Torx driver to remove (2) screws securing
the overhead console. (Figure 15)
Figure 15
32. Attach 10-pin mirror connector of supplied Mirror
Harness to vehicle 10-pin connector. (Figured 16)
Figure 16
33. Using your fingers, pull down on the windshield
header edge of the headliner and route the 10-pin
connector portion of the mirror harness back toward
the center of the overhead console.
34. Route 16-pin connector of supplied Mirror Harness
through the center of the overhead console, out the
front edge of the headliner. (Figure 17)
Figure 17