Bowers Group Trimos V+ Series Height Gauges - Manual (Page 12)

TRIMOS SA Av. de Longemalle 5 CH 1020 Renens Switzerland
Tel ++ 41 21 633 01 01 Fax ++41 21 633 01 02 [email protected] http://www.trimos.ch
Page 12
11. Main functions
Switches the instrument ON or OFF.
Sending data RS232, only when measuring.
((See page 18) for other settings)
Set the display at zero or memorizes preset values.
Normal key mode, green light on, measuring heights of normal and
Reversed surfaces. (The probe constant must have been previously
entered to measure reversed surfaces.
Ж
Ж , key mode, orange light on, measuring diameter (takes account of
probe constant).
Measures internal or ecternal diameters in any sequences.
⊕ ⊕ , key mode, yellow light on, displays the centerline. Comes after the
diameter display, as soon as :
- the probe is released or
- the Normal, Æ,
⊕ key is pressed.
Displays the probe value. Return to measuring mode
without change : press any key.
- Measuring the constant : one measurement on each side of the
setting gauge (see page 13).
Changes the display resolution : 0.001mm <-> 0.01mm
or : .00005 ’’ <-> .0005 ’’
Direct conversion of mm <-> inches.
Reinitialises the maximum, minimum and delta memories.
Change of reference mode (REFI / REFII)
Modes : Minimum -> Maximum -> Delta