Bird Technologies SA-1700-P - Manual (Page 23)

Getting Started
13
Power Up
On first power up or after a failure set the unit to
default parameters. Refer to “Return to Defaults”,
page 83.
Self Test
A self test is run at power up. If the test fails, see
“Troubleshooting” on page 90 for instructions. If the
problem persists, return the unit for service.
The software revision information is displayed during
the self test, as shown below.
System
Information
Have the following system information ready before
you begin using the Site Analyzer:
Frequency
— ex: 33.00 – 33.18 MHz (emergency band)
Cable Type
— ex: LDF 7-50A
Approximate Cable Length
— ex: 300 feet
Transmitter Power
— ex: 50 W
Model SA-1700, 25 - 1700 MHz
SN: 00000000
Copyright © 1998 - 2002 by Bird Electronic Corporation
25 Nov 2002
WARNING
This equipment should not be connected to an
antenna or operated during a storm that has the
potential to produce lightning. The possibility exists
for electrical shock.