Bird Technologies AT-800-Manual - Manual (Page 53)

Measure Match
35
Single Frequency
This mode is useful for tuning antennas, particularly
with the audio on. The frequency can be selected man-
ually or by selecting the channel. The correct cellular
system and base or mobile should be selected and
shown in the top right corner of the display.
Selecting the Frequency - User Defined
1. Press the MENU key.
2. Press the MEAS MATCH key.
3. Press the SINGLE FREQ key.
4. Press the FREQ MHZ key.
Note: The cursor will be blinking at the
frequency and Freq MHz will be highlighted.
5. Enter the desired frequency using the numeric
keypad or change the value using the UP/DOWN
arrow keys.
6. Press the ENTER key.
Note: The measured value and the fre-
quency will be shown at the top of the display.
Selecting the Frequency - Automatically
1. Repeatedly press the SELECT key until the cursor
is blinking on CH (channel).
2. Use the numeric keypad or UP/DOWN arrow
keys to change the value.
3. Press the ENTER key. The frequency will change
to correspond to the selected channel.