Bird Technologies AT-800-Manual - Manual (Page 48)

Bird AT-800 Antenna Tester
30
Note: If a full register is selected, the new
trace will overwrite the old trace.
Note: If registers 1-4 are full press the
MORE SAVE key to access 5-8 and again to
access 9-12. If needed, use the ESC key to back up.
Note: It is a good idea to keep a record of
which traces are in which register as they are
identified by register number only.
Recalling a Trace
Follow the steps below to recall a saved trace.
1. Press the MENU key.
2. Press the MEAS MATCH key.
3. Press the SWEPT FREQ key.
4. Press the TRACE key.
5. Press the RECALL TRACE key.
6. Press the REG-n key for the desired trace, press
the MORE RECALL key to access 5-8 and again
to access 9-12.
Note: If needed, use the ESC key to back
up. The saved trace will be displayed and the
corresponding register number will be shown
at the bottom of the display. The arrow keys
will move the cursor as normal.
7. Press the RETURN key to return to register selection.
8. Press the ESC key to return to trace menu.