Bird Technologies SK-4000-TC-Manual - Manual (Page 18)

6
Power
The SiteHawk SK-4000 Analyzer has an internal, rechargeable, lithium-ion bat-
tery pack.
CAUTION
Only use the supplied AC adapter to charge the unit.
The unit cannot be charged from a standard USB port (i.e. from a laptop).
Charging from a standard USB port could damage the power source.

The unit will operate for a minimum of 4 hours of continuous usage.

Recharging time, from a full discharge, is approximately 5 hours.
Note: When the unit is received the battery may not be fully
charged. An AC adapter should be used when operating the unit for
the first time.
Powering On
1. Press Power Key for 5 seconds.
2. Release power key.
Note: Unit will complete power-up in approximately 30 secs.
Powering Off
1. Press Power Key for three seconds.
Note: Power off reboot airplane mode.
2. Select Power Off.
3. Press Ok.
Sleep Mode
Press and release Power key.
Note: The display screen will be shut down. The SiteHawk SK-4000
Analyzer will still be on.
Measurement Port
The measurement port is an 50 ohm N-type. This port is used to connect the
DUT.