Bendix Commercial Vehicle Systems XVISION NIGHT VISION SYSTEM 8/11 - Manual (Page 4)

4
CB STYLE MOUNTING KIT (PIECE NO. 5010081)
The CB style mounting kit contains the necessary mounting
hardware for the CB style dashboard option and CB
style overhead option. When the display is mounted, the
combiner surface (and virtual image) must be viewable in
the driver’s peripheral vision. A template is provided to
help guide the drilling of holes.
The CB style mounting kit includes the following items.
Mounting brackets (piece no. 5009616) – The CB style
mounting kit includes two mounting brackets that can be
used for either the CB dashboard mount or CB overhead
mount.
IR CAMERA BRACKET KIT (PIECE NO. 5010078)
INCLUDES:
Mounting Bracket Kit (piece no. 5010187) – The mounting
bracket is designed to mount to the vehicle roof (horizontal
mounting) or faring area (vertical mounting) and needs to
be mounted parallel to the lateral axis of the vehicle (side
to side). A template is provided to help guide the drilling of
holes. Two stud plates with 1/4-20 studs mount the bracket
to the vehicle. The final torque on the studs should be
90-100 in-lbs.
IR Camera Bracket with Aiming Adjusters (piece no.
5010673) – One IR camera bracket is provided in the IR
camera bracket kit. The bracket includes a standoff base,
standoff pivot assembly and aiming adjusters all of which
are pre-installed.
The mounting bracket kit also includes shims that should
be used to level the mounting bracket. A sealant is to be
used between the vehicle, mounting bracket, and stud
plate. Verify that the sealant has been applied appropriately,
according to the Installation Instructions. Additional
mounting hardware is also included in the kit.
Cable Tie – A cable tie (to fasten the IR camera harness
to the IR camera bracket) is also included in the IR camera
bracket kit.
Hardware – The IR camera bracket kit includes all of the
necessary hardware to assemble the IR camera, IR camera
bracket, and mounting bracket.
FIGURE 2 - MOUNTING BRACKET ORIENTATIONS
Horizontal Mounted Bracket
(Roof Mount)
Vertical Mounted Bracket (Faring
Mount)
Stud Plate
Apply sealant
between
these
surfaces
Add shims if the
surface is not
level
Roof
FIGURE 3 - MOUNTING BRACKET KIT CONTENTS
FIGURE 4 - IR CAMERA BRACKET WITH AIMING
ADJUSTERS
Aiming Adjuster Assemblies
Standoff and
Pivot Assembly
Holes for Harness
Cable Tie
Parts/kits listed are now obsolete and are no longer serviceable through Bendix.