Bendix Commercial Vehicle Systems XVISION NIGHT VISION SYSTEM 8/11 - Manual (Page 17)

17
Display Bracket Replacement - CB Style Mount
(Overhead)
Refer to
CB Style Mount (Dashboard) procedure.
Display Bracket Replacement - Friction Hinge
Mount (Visor)
1. Unscrew and disconnect the 25-pin connector of the
display harness.
2. Flip the display down to allow access to the friction
hinge supports.
3. Remove the four #10 Plastite ® pan head screws that
secure the display to the headliner.
4. Remove the two M2.5 threadroll pan head screws that
secure the friction hinge supports to the display.
5. Secure the new friction hinge supports to the display
with the M2.5 threadroll pan head screws.
IMPORTANT: Do not exceed 15 in-lbs. when
fastening. If 15 in-lbs. are exceeded, the screw head
will shear off or the standoffs will strip. The threadroll
screws will form threads in the standoffs as they are
tightened. If it feels as though the screw is binding,
back out the screw slightly and continue to tighten
to prevent breakage.
6. Secure the new friction hinge supports to the headliner
with the four #10 Plastite ® pan head screws. Torque the
screws to approximately 15 in-lbs.
7. Reconnect the 25-pin connector of the display harness.
Base Plate 8-32 Mounting
Four 8-32 inserts are provided in the display base.
A template is provided to help guide the drilling
of holes. Use a 13/64 in. bit for drilling the four clearance
holes. Typically, this installation is used when the display
is being recessed.
FIGURE 30 - WASHERS AND THREADED KNOBS [SHOWN
IN CB STYLE MOUNT (OVERHEAD) POSITION]
Display Bracket Replacement - CB Style Mount
(Dashboard)
1. Unscrew and disconnect the 25-pin connector of the
display harness.
2. Unscrew the threaded knobs from the display and
brackets. Set the display, knobs, and washers aside.
Exercise care to prevent dropping the washers into the
venting on the dash.
3. Remove the four #10 Plastite ® pan head screws from
the brackets and dashboard. Set the four screws aside.
4. Secure the replacement brackets with the four screws
from Step 3.
5. Torque the screws to approximately 20 in-lbs.
6. Slide one of the washers onto one of the threaded
knobs.
7. Hold one washer between the display and a bracket
while threading the washer/knob from the outside of
the bracket. See Figure 30.
8. Repeat steps 6 and 7 for the other side of the display.
9. Reconnect the 25-pin connector of the display harness.
Parts/kits listed are now obsolete and are no longer serviceable through Bendix.