Bendix Commercial Vehicle Systems XVISION NIGHT VISION SYSTEM 8/11 - Manual (Page 19)

19
21. Loosely install the harness tie-wrap around the
harness.
22. Position the IR camera onto the factory-installed
aiming assemblies. Refer to Figure 33.
23. Rotate the pivot locks on the ends of the aiming
assemblies 1/4 turn clockwise using the included
aiming adjuster tool. This will lock the IR camera in
position.
FIGURE 33 - FULLY ASSEMBLED CAMERA
24. Securely tighten the harness cable tie.
25. Ensure that the harness reaches the “A” pillar without
trouble. Once the shroud assembly is heat-shrunk, the
harness cannot be moved or adjusted.
26. After the IR camera harness is properly secured and
routed, heat-shrink the shroud assembly from the
outside of the vehicle, using a heat gun.
WARNING: Do not touch the shroud assembly after
it has been heat-shrunk. It will be hot and may
cause burns.
IMPORTANT: Be careful not to melt the wiring or
o-ring during the heat shrinking process.
FIGURE 32 - CONNECTING THE CAMERA HARNESSES
Cable Tie
6-pin connector
2-pin connector
wrench to approximately 15 to 20 in-lbs. or until the
o-ring is slightly flattened.
16. Route the IR camera harness to the “A” pillar of the
cab.
17. Connect the 8-pin connector of the IR camera harness
to the display harness.
18. Pull the IR camera harness through the opening
between the IR camera bracket and mounting bracket.
19. Plug the 2-pin connector of the IR camera harness
into the window heater. Refer to Figure 32.
20. Plug the 6-pin connector of the IR camera harness
into the IR camera connection. Refer to Figure 32.
FIGURE 31 - HEAT SHRINKABLE SHROUD ASSEMBLY
Externally
Threaded Nut
3 in.
(Appro
xima
tely)
O-Ring
Heat Shrinkable Shroud
Parts/kits listed are now obsolete and are no longer serviceable through Bendix.