3 displaying or changing parameter values – Rockwell Automation GV3000/SE 230VAC 1-20 HP GP & Vector Drive Ver. 6.04 Software Start-Up and Ref. User Manual

Page 89

4-3

Programming Reference

Parameter Name: the name assigned to a parameter number. The parameter
name is not displayed when programming the drive using the keypad/display.
The parameter name is only visible when using the CS3000 software or Operator
Interface Module (OIM).

Parameter Description: a description of the parameter's function.

Parameter Range: the predefined parameter value limits or selections.

Default Setting: the factory default setting.

Parameter Type: identifies whether the parameter is tunable, configurable, or
read only.

Refer also to parameters: a list of associated parameters that may provide
additional or related information.

4.3

Displaying or Changing Parameter Values

Use the following procedure to display or change parameter values:

Step 1. Press the PROGRAM key until the PROGRAM LED turns on to enter

program mode.

One of the main parameter menus (P.---,
H.---, U.---, Err, etc.) will be displayed.

Step 2. Use the

key or the

key to move through the menus.

Note that if P.--- and Err are the only two
menu selections displayed, access to the
Second Menu parameters has been
restricted. A password must be entered into
parameter P.006 in order to access the
Second Menu parameters. Refer to section
4.6 for this procedure.

AUTO

MAN

Forward
Reverse

PROGRAM

RUN
JOG

STOP

RESET

START

ENTER

SPEED
VOLTS
AMPS
Hz
Kw
TORQUE
Password

RUNNING
REMOTE
JOG
AUTO
FORWARD
REVERSE
PROGRAM