Rockwell Automation 6181X-12TPXPDC Industrial Integrated Computers for Hazardous Locations - Manual (Page 24)

24 Rockwell Automation Publication 6181X-UM001B-EN-P - May 2011
Chapter 2 Installation
4. Slide the mounting clips into the holes on the top, bottom, and sides of the
computer.
5. Gradually tighten the clips, one at a time, around the bezel by using the
specified sequence starting with the center clips and continuing to the
corner clips.
6. Tighten the mounting clips to a torque of 1.4 N•m (12 lb•in) by using the
sequence in step 5, being sure not to overtighten.
Repeat this process at least three times until the clips are properly torqued,
making sure the gasket is compressed uniformly against the panel.
ATTENTION: Tighten the mounting clips to the specified torque to
provide a proper seal and prevent damage to the product. Rockwell
Automation assumes no responsibility for water or chemical damage to
the product or other equipment within the enclosure because of improper
installation.
1 10 9
2
7 8
5
4
3
6