Chapter objectives, Communications system? -1, Chapter 5 – Rockwell Automation 9303 DRIVE TOOLS32 GETTING STARTED User Manual
Page 55: Chapter

Publication 9303-5.13 – March 1998
Chapter
5
Setting Up a DH+ to RIO Block Transfer Pass Thru
Communications System
Chapter Objectives
This chapter provides information for configuring a communication system that
uses DH+ to Remote I/O (RIO) Block Transfer Pass Thru. After you finish
reading this chapter, you will be able to perform the following tasks:
•
Check your hardware installation.
•
Configure RSLinx for DH+ to RIO Block Transfer Pass Thru
communications.
•
Enter information into the DriveTools32 application’s Communication
Setup dialog box.
•
Begin communicating with your drive.
What is a DH+ to
RIO Block Transfer
Pass Thru
Communications
System?
A Data Highway Plus (DH+) to RIO Block Transfer Pass Thru communications
system lets your PC communicate with drive products using the PLC-5 RIO
Block Transfer Pass Thru mechanism.
Important: A DH+ to RIO Block Transfer Pass Thru communications system
also works with an SLC-500 family processor using a Series B 1747-SN RIO
scanner in slot 1.
The RIO Block Transfer Pass Thru mechanism requires that a drive be
connected to a PLC-5 as an RIO device on the PLC’s RIO network. You can
connect a drive as an RIO device using several different hardware options
depending on the drive type. These options include:
This drive:
Requires that you use the hardware option:
1395
Node adapter (1395-KP50) or
multi-communications adapter (1395-KP51)
SCANport-Compatible Products
1203 Remote I/O Communications Module
(1203-GD1, 1203-GK1, or 1336-GM1)
1336 (FORCE)
PLC Communications Adapter Board
(1336T-GT1EN) or 1203 Remote I/O
Communications Module (1203-GD1, 1203-GK1,
or 1336-GM1)