Rockwell Automation 9329 Drive Application Software Tension Control Gen. Units - Manual (Page 48)

FM – Tension Control
Drive Application Software – page 48 of 52
The following table is a functional list of the Process Line status word
[DLx_DrvStatProcLn]
Bit Output Signal Description
00 Fault Drive Fault or a System Fault
01 Running Drive is Running / not stopping
02 Reserved
03 Motor Ctrl On Motor is being control (Motor POWER)
04 Reserved
05 Jogging section Jogging
06 Rotational Reverse Under Wind
07 Tension Control On Selected mode of Tension control is enabled
08 Zero Speed Below Zero Line speed set point
09 Diameter Calculation Active Future
10 Reserved
11 Reserved
12 Reserved
13 Reserved
14 Reserved
15 Reserved
16 Enable Loss Fault Drive Enable lost
17 Fail to Run fault Drive failed to start
18 Communication fault NA – not support
19 Message fault NA – not support
20 Motor Overload Fault Overload alarm from drive
21 Motor Overtemperature Flt Over temperature alarm from drive
22 Motor Blower Loss Fault Motor blower has stopped or tripped off
23 Reserved
24 Reserved
25 Reserved
26 Reserved
27 Reserved
28 Reserved
29 Reserved
30 Operate Permissive
Use in line control logic to command a
coordinated line ramp stop.
31 On Permissive
Loss of permissive resets start command.
The drive will coast stop or ramp stop
depending on configuration