beautypg.com

Mount the display computer in a panel – Rockwell Automation 6181X-12TPXPDC Industrial Integrated Computers for Hazardous Locations User Manual

Page 13

background image

Industrial Computers for Hazardous Locations 13

Rockwell Automation Publication 6181X-IN001C-EN-P - April 2011

Mount the Display Computer in a Panel

Mounting clips secure the 6181X-12TPXPDC display computer to the panel. Make sure to
mount the computer vertically.

Panel Mounting Guidelines

Observe these guidelines when installing the unit in a panel:

Remove all electrical power from the panel before making the cutout.

Confirm that there is adequate space behind the panel. For specific information refer to

Mounting Clearances

on

page 10

.

Cut supporting panel cutout to specifications before installation. Take precautions so
metal cuttings do not enter components already installed in panel.

Supporting panels must be of specified thickness to be sure of proper sealing against
water and dust and to provide proper support. The mounting hardware supplied
accommodates panel thickness between 14…8 GA or 1.6…4.2 mm (0.063…0.165 in.).

Make sure the area around the panel cutout is clear.

Panel Cutout Dimensions

The 6181X-12TPXPDC display computer must be appropriately mounted in the panel cutout
specified below.

Follow these steps to mount the computer in a panel.

1.

Remove power from the panel.

2.

Cut an opening in the panel by using the appropriate panel cutout dimensions.

3.

Place the computer in the panel cutout.

Failure to follow these guidelines may result in personal injury or damage to
the panel components.

Computer

Cutout Dimensions (HxW), approx.

6181X-12TPXPDC

254.0 x 324.0 mm (10.0 x 12.76 in.)

This manual is related to the following products: