Install the computer, Mount the non-display computer on a wall – Rockwell Automation 6181X-12TPXPDC Industrial Integrated Computers for Hazardous Locations User Manual
Page 12
12 Industrial Computers for Hazardous Locations
Rockwell Automation Publication 6181X-IN001C-EN-P - April 2011
Install the Computer
The computers support these mounting options.
Mount the Non-display Computer on a Wall
Four mounting screws secure the non-display computer to a metal wall, such as a steel mounting
panel in an enclosure or equipment room.
Follow these steps to mount a non-display computer.
1.
Disconnect power from the computer.
2.
Attach the two of the supplied M4 panhead screws with grommets to the 1 and 2 screw
position as illustrated below.
3.
Mount the computer on the wall and then attach the remaining two M4 panhead screws
with grommets to the 3 and 4 screw position.
4.
Tighten the screws to a torque that is appropriate for the screw and wall.
Recommended torque in steel is 1.13…1.36 N•m (10…12 lb•in).
The illustration shows the location of the screw holes with the dimensions given in
mm (in.).
Cat. No.
Computer Model
Mounting Option
6181X-NPXPDC
Non-display
Wall mount
6181X-12TPXPDC
(1)
(1)
Display computers must be securely mounted by using all mounting clips.
Display
Panel mount
IMPORTANT
Do not mount the non-display computer on a horizontal surface.
335.28 (13.2)
190.50 (7.50
)