Rockwell Automation 6182 Industrial Computer for the Windows CE Operating System - Manual (Page 54)

5–4 Installing/Removing Front Bezel Assembly Items
Publication 6182-UM001D-EN-P
7. Reinstall the 6 screws to attach the metal cover to the frame. Tighten
the screws to a torque of 6 - 8 in–lbs (0.7 - 0.9 N•m).
8. Follow the procedures on Page 4-2 to reassemble the front bezel
assembly to the computer chassis.
To disassemble the front bezel (12.1 in. display with touchscreen):
1. Disconnect the backlight tube connectors as indicated in the
following figure:
2. Remove the 6 screws securing the metal cover to the frame.
Note: The touchscreen controller board for the 12.1-in.
touchscreen-only version is attached to the metal cover.
Do not damage the touchscreen cable when loosening
the cover.
3. Disconnect the touchscreen cable and remove the cover.
4. If you are replacing the plastic bezel overlay or vertical legend
strips, remove the 10 screws securing the metal frame and lift the
metal frame away from the plastic bezel.
5. To reassemble the front bezel assembly, thread the touchscreen cable
through the hole in the metal frame.
6. If you are replacing the plastic bezel overlay or vertical legend
strips, reinstall the 10 screws to attach the metal frame to the plastic
overlay assembly. Tighten the screws to a torque of 6 - 8 in–lbs (0.7 -
0.9 N•m).
7. Replace the metal cover and reconnect the touchscreen cable.