Rockwell Automation 6182 Industrial Computer for the Windows CE Operating System - Manual (Page 44)

4–6 Adding/Removing Internal Components
Publication 6182-UM001D-EN-P
One PCI card can be installed in the RAC6182 computer. While the
RAC6182 expansion slot is electrically compatible with any standard
half-length PCI card, special Windows CE drivers are required to make a
PCI card function on the RAC6182 computer. Refer to the application
program to make sure it supports the desired PCI card.
The following PCI cards are available as factory-installed RAC6182
options, and are supported by Rockwell Software's RSView Machine
Edition application version 1.0.
Part Number Description
1784-PKTX Single-channel DH+/RIO/DH485 network card
ATTENTION: Review safety precautions and
information on thermal considerations for add-in cards on
Page 4-2 before proceeding.
Failure to follow proper safety procedures could result in
severe electrical shock or damage to the RAC6182
Industrial Computer.
ATTENTION: Add-in cards may be sensitive to ESD
and require careful handling. Hold cards only by the
edges--do not touch connectors. After removing a card,
place the card on a flat static free surface, component side
up. Do not slide the card over any surface.
To install a PCI card:
To complete this procedure, you will need a #1 and a #2 Phillips head
screwdriver.
1. Turn off power to the RAC6182.
2. Remove the 2 screws securing the top cover to the chassis.
3. Remove the screw securing the slot cover and remove the slot cover.
Adding/Removing a
PCI Card