Rockwell Automation 1779-KP3R DATA HIGHWAY II - Manual (Page 41)

Programming
Chapter 3
3Ć6
Where: is:
TO the qualifier that specifies the destination of the data transfer; you
can abbreviate as T. You must specify the TO qualifier and it must
be followed an address (which must include a data table address
and can include a remote node address).
the destination address for the data you are moving. This is either
a Data Highway II node address or programmable controller
memory address (see section titled Addressing Techniques for
addressing style information).
These are examples of using the TMOVE command with the FROM
qualifier:
TMOVE FROM :66$010 TO $B2:3
TM F $B2:3 T :66$010
Syntax for the TMOVE Command With an Integer Constant
The syntax for the TMOVE command when using an integer constant is:
TMOVE TO
Where: is:
TMOVE the command that tells the KP3 to transfer data to or from a remote
node.
what you use in place of the FROM qualifier. The correct format is
#digit, where digit is either 0 or 1.
TO the qualifier that specifies the destination of the data transfer; you
can abbreviate as T. You must specify the TO qualifier and it must
be followed an address (which must include a data table address
and can include a remote node address).
the destination address for the data you are moving. This is either
a Data Highway II node address or programmable controller
memory address (see section titled Addressing Techniques for
addressing style information).
These are examples of using the TMOVE command with an integer
constant:
TMOVE #1 TO :76$222/3
TM #0 T :76$B2:3/4