Rockwell Automation 1746-XXXX SLC 500 4-Channel Analog I/O Modules User Manual - Manual (Page 30)

Publication 1746-UM005B-EN-P - June 2004
3-8 Installing and Wiring Your Analog Module
2. Align the circuit board of the analog module with the card guide
of the chassis.
3. Slide the module in until both top and bottom retaining clips are
secured.
4. To remove the module, depress the retaining clips at the top and
bottom of the module and slide the module out.
Wiring Considerations The following section provides system wiring guidelines, how to
ground your Belden cable, and how to determine the cable length.
Card Guide
Top and Bottom Module Release(s)
ATTENTION
Before wiring any analog module, disconnect power
from the SLC 500 system and from any other source
to the analog module.