3 - installing and wiring your analog module, European union directive compliance, Chapter 3 – Rockwell Automation 1746-XXXX SLC 500 4-Channel Analog I/O Modules User Manual User Manual
Page 23: Installing and wiring your analog module, European union directive compliance -1, Emc directives -1, Chapter

1
Publication 1746-UM005B-EN-P - June 2004
Chapter
3
Installing and Wiring Your Analog Module
To obtain the maximum performance from an analog module, proper
module installation is imperative. This chapter describes the
procedures that you must follow to install the analog module in an
SLC 500 system. The following items are described:
•
European Union Directive Compliance
•
determining your power requirements
•
configuring your module
•
selecting a slot in the chassis
•
installing your module
•
wiring considerations
– system wiring guidelines
– grounding your cable
– determining the cable length
•
wiring the analog module
•
minimizing electrical noise on the analog module
European Union Directive
Compliance
If this product is installed within the European Union or EEA regions
and has the CE mark, the following regulations apply.
EMC Directives
This product is tested to meet Council Directive 89/336/EEC
Electromagnetic Compatibility (EMC) and the following standards, in
whole or in part, documented in a technical construction file:
•
EN 50081–2
EMC - Generic Emission Standard, Part 2 - Industrial
Environment
•
EN 50082–2
EMC - Generic Immunity Standard, Part 2 - Industrial
Environment
This product is intended for use in an industrial environment.