Rockwell Automation 1747-AENTR SLC 500 EtherNet/IP Adapter User Manual - Manual (Page 13)

Rockwell Automation Publication 1747-UM076C-EN-E - January 2013 7
Chapter
2
Install Your Adapter
This chapter describes how to install the 1747-AENTR adapter and connect it to
the EtherNet/IP network.
The following table lists where to find specific information.
Set the Network Address
Switches The network address switches are set to 999 and DHCP enabled, by default. You
can set the network Internet Protocol (IP) address in the following ways:
• Use the network address switches on the module.
• Use a Dynamic Host Configuration Protocol (DHCP) server, such as
Rockwell Automation BootP/DHCP.
• Retrieve the IP address from nonvolatile memory.
The adapter reads the network address switches first to determine if the switches
are set to a valid number. You set the node address by using the network address
switches. Valid settings range from 001…254.
When the switches are set to a valid number, the adapter’s IP address is
192.168.1.xxx (where xxx represents the number set on the switches).
Topic Page
Set the Network Address Switches 7
Determine Power Requirements 8
Install the Adapter Module in the Chassis 8
Connect Your Adapter to the Ethernet/IP Network through RJ-45 Connection 9
Chapter Summary 11