Rockwell Automation 1784-PCC ControlNet Communication Card Installation Instructions - Manual (Page 70)

5-2 Install and Use the 1784-PCC Card in Windows 95/98/Me
Publication 1784-IN034D-EN-P - June 2002
Locate the 1784-PCC Windows 95/98/Me Driver
When you install drivers for your operating systems, you must be certain to install
the correct files. Windows 95/98/Me systems require a Virtual Device Driver (VxD),
which contains .inf and .vxd files. Refer to the table below to be sure you are
installing the correct driver files.
Install the 1784-PCC Driver
Follow the procedures below to install the Windows 95/98/Me driver for the
1784-PCC Series A or B card.
1. In Windows 95/98/Me, insert the card into the PCMCIA slot by following the
directions in Chapter 7.
ATTENTION
!
Failure to install the correct driver files could result in
unpredictable system operation.
Table 5.B
Source (where the
driver is loaded
from) Driver location (for Windows 95/98/Me operating systems)
installation disk
version 1.6
1
(shipped
with the 1784-PCC
card)
A:\Rsipcc.inf
A:\Rsipcc.vxd
where
A:\ is the floppy drive letter
RS-Linx 2.20.01 or
later product CD E:\PnP_Drivers\Win9x\Rsipcc.inf
E:\PnP_Drivers\Win9x\Rsipcc.vxd
where
E:\ is the CD-ROM drive letter
internet www.ab.com/support/products/pccards.html
You can also access Rockwell Automation Knowledge documents
at this site.
1
If your installation disk is earlier than version 1.6, we recommend downloading the latest
version from www.ab.com/support/products/pccards.html.