Rockwell Automation 1305 AC Drive, Firmware 1.01-3.00 User Manual - Manual (Page 95)

Chapter 5 – Programming
5-27
Table 5.B Accel/Decel Selection
Parameter Settings Frequency Source ➀ Accel/Decel Control Terminal Block
Preset/
2nd
Accel(26) Upper
Presets
(72)
Freq
Select 1
(5) Freq
Select 2
(6)
Preset Freq 1
(27)
Preset Freq 2
(28)
Preset Freq 3
(29) Preset Freq 4
(73)
Preset Freq 5
(74) Preset Freq 6
(75)
Preset Freq 7
(76) Accel Time 1
(7)
Decel Time 1
(8)
Accel Time 2 (30) Decel Time 2 (31)
SW3
TB2-18 SW2
TB2-17 SW1
TB2-16
• • • 0 0 0
• • • 0 0 X
• • • 0 X 0
Disabled
• • • 0 X X Disabled
➁ • • • X 0 0
• • • X 0 X
• • • X X 0
2nd
A el
• • • X X X
2nd
Accel • • • 0 0 0
• • • 0 0 X
• • • 0 X 0
Ena led
• • • 0 X X
Enabled
• • • X 0 0
• • • X 0 X
• • • X X 0
• • • X X X
➀ The parameter [Freq Source] indicates the active frequency source. See p. 5-40. ➁ Factory default settings.
• Indicates active function/parameter. X Indicates closed switch. 0 Indicates open switch.
(26) Indicates parameter number.
Frequency Set Group (cont.)