Rockwell Automation 1203-SM1 SLC to SCANport Communication Module - Manual (Page 76)

SCANport Messaging B–10
Publication 1203–5.9 –– October 1996
Write Value to Parameter
The Write Value to Parameter message lets you write a value to a
specific parameter. The following is an example of this request:
Service=Set Attribute Single
Parameter Class
Instance=Parameter #5
Attribute=Value
Data Length=2 Bytes
M0:e.000
M0:e.001
M0:e.002
M0:e.003
M0:e.004
0010
000f
0005
0001
0002
Value
Write a Value of 6 to Parameter 5
Service=Set Attribute Single
Parameter Class
Instance=Parameter #5
Attribute=Value
Data Length=0 Bytes
M1:e.100
M1:e.101
M1:e.102
M1:e.103
M1:e.104
0010
000f
0005
0001
0000
Value
Response
Data=Value of 6 M0:e.005 0006
Figure B.7 shows an example of a Write Value to Parameter request.
The drive accepted the message, and parameter number 5 now has a
value of 6.
Figure B.7
Example of Write Value to Parameter
address 0 1 2 3 4 5 6 7 8 9
N10:0 0010 000f 0005 0001 0002 0006 0000 0000 0000 0000
address 0 1 2 3 4 5 6 7 8 9
N11:0 0010 000f 0005 0001 0000 0000 0000 0000 0000 0000