Overview, Chapter objectives, What is the slc to scanport module – Rockwell Automation 1203-SM1 SLC to SCANport Communication Module User Manual
Page 11: Chapter, Chapter 1 provides descriptions of the following, The slc to scanport module, Figure 1.1 example slc to scanport module set up
Chapter
1
Publication 1203–5.9 –– October 1996
Overview
Chapter 1 provides descriptions of the following:
•
the SLC to SCANport module
•
the available functions
The SLC to SCANport module provides an interface between any
SLC processor or other product that can control modules within a
SLC rack and up to three SCANport devices as shown in Figure 1.1.
Figure 1.1
Example SLC to SCANport Module Set Up
INPUT
OUTPUT
SCANport
Channel 1
Channel 2
Channel 3
CHANNEL 1
CHANNEL 2
CHANNEL 3
SLC 5/01 CPU
PC RUN
CPU Fault
FORCED I/O
BATTERY LOW
POWER
0
8
1
9
2
10
3
11
7
15
6
14
5
13
4
12
0
8
1
9
2
10
3
11
7
15
6
14
5
13
4
12
SLC Rack with
SLC to SCANport Module
SMC Dialog Plus
1305
1336 PLUS
To connect more than three SCANport devices in a single rack, add
additional SLC to SCANport modules to your SLC rack system.
You can use your SLC to SCANport module in a 4, 7, 10, or 13 slot
SLC rack or a 2–slot expansion rack available for the fixed I/O
configurations of SLC–500 processors.
Important: An SLC rack using this module needs an enclosure of at
least 200 mm (8 in) in depth. You cannot place an SLC
rack using the SLC to SCANport module in a 150 mm
(6 in) deep enclosure.
Chapter Objectives
What is the SLC to
SCANport Module?