Rockwell Automation 1203-SM1 SLC to SCANport Communication Module - Manual (Page 38)

4–10 Using Enhanced Mode
Publication 1203–5.9 –– October 1996
You can use G files to enable additional I/O (datalinks) between the
SCANport device and the SLC to SCANport module. G files also
hold the safe state values for the output data to be transferred to the
SCANport devices when it is switch–configured to use it. The G file
data is specified as follows: G=g–file, s=slot
Figure 4.8
G File Image
G File Image
Reserved Gs:0
atalin Datalink Enables Gs:1 Datalink
on i u ation
Logic Command Channel 1 Gs:2
atalin
Configuration
i ld
Analog Reference Channel 1 Gs:3
Field
Logic Command Channel 2 Gs:4
Analog Reference Channel 2 Gs:5
Logic Command Channel 3 Gs:6
Analog Reference Channel 3 Gs:7
Channel 1 Datalink A1 Input Gs:8
Channel 1 Datalink A2 Input Gs:9
Channel 1 Datalink B1 Input Gs:10
Channel 1 Datalink B2 Input Gs:11
Channel 1 Datalink C1 Input Gs:12
Channel 1 Datalink C2 Input Gs:13
Channel 1 Datalink D1 Input Gs:14
Channel 1 Datalink D2 Input Gs:15
Channel 2 Datalink A1 Input Gs:16
a
Channel 2 Datalink A2 Input Gs:17
Safe
tat
Channel 2 Datalink B1 Input Gs:18
State
Configuration
Channel 2 Datalink B2 Input Gs:19
Configuration
Data
Channel 2 Datalink C1 Input Gs:20
ata
Channel 2 Datalink C2 Input Gs:21
Channel 2 Datalink D1 Input Gs:22
Channel 2 Datalink D2 Input Gs:23
Channel 3 Datalink A1 Input Gs:24
Channel 3 Datalink A2 Input Gs:25
Channel 3 Datalink B1 Input Gs:26
Channel 3 Datalink B2 Input Gs:27
Channel 3 Datalink C1 Input Gs:28
Channel 3 Datalink C2 Input Gs:29
Channel 3 Datalink D1 Input Gs:30
Channel 3 Datalink D2 Input Gs:31
Configuring G Files