Compliance to european union directives – Rockwell Automation 1402-LSM Line Synchronization Module Installation Instructions User Manual
Page 82

Appendix E
Technical Specifications
E–4
If this product has the CE mark it is approved for installation within the
European Union and EEA regions. It has been designed and tested to meet
the following directives.
EMC Directive
This product is tested to meet Council Directive 89/336/EEC
Electromagnetic Compatibility (EMC) and the following standards, in whole
or in part, documented in a technical construction file:
•
EN 50081-2 EMC – Generic Emission Standard, Part 2 – Industrial
Environment
•
EN 50082-2 EMC – Generic Immunity Standard, Part 2 – Industrial
Environment
This product is intended for use in an industrial environment.
Low Voltage Directive
This product is tested to meet Council Directive 73/23/EEC Low Voltage, by
applying the safety requirements of EN 61131–2 Programmable Controllers,
Part 2 – Equipment Requirements and Tests.
For specific information required by EN 61131-2, see the appropriate
sections in this publication, as well as the following Allen-Bradley
publications:
•
Industrial Automation Wiring and Grounding Guidelines For Noise
Immunity, publication 1770-4.1
•
Automation Systems Catalog, publication B111
This equipment is classified as open equipment and must be installed
(mounted) in an enclosure during operation as a means of providing safety
protection.
Wiring Requirements for CE Compliance
For CE compliance, line filters are required for all voltage input lines.
(Comcor P/N 10VB1 or equivalent suggested.) Filters should be placed
within 0.5 meters of LSM swing-arm.
Compliance to European
Union Directives