Rockwell Automation 442L Safety Configuration & Diagnosis (SCD) User Manual - Manual (Page 7)

Rockwell Automation Publication 10000455426 Ver 00 - January 2013 5
Chapter 2 User interface
How to show or hide the toolbars:
 From the View menu select the Toolbar command.
If the toolbar was hidden before, it will now be shown.
If the toolbar was shown before, it will now be hidden.
User interface navigation area Figure 4 - User interface navigation area
The navigation area shows the devices in a device cluster hierarchically in a
project tree.
The icons at the lower margin of the navigation area can be used to have the
type code, the configuration CRC (check sum), the user group or the online state
of the individual devices displayed in the project tree.
The project tree consists of:
•
A project icon
• An icon for the communication protocol
• One or more icons for the physical connections at your PC that support the
communication protocol
• One or more device icons
Table 2 - Icons in the project tree
In the navigation area you can call up various commands by using the pop-up
menus of the project, of the communication protocol, of the connections or of
the devices.
Note If some commands are shown in grey, the commands are currently not available
(because the SCD is, for example, not connected to a device) or because you do
not have sufficient access rights.
Table 3 - Icons in the user interface navigation area
Icon Meaning of the icon
Project/Communication protocol
Physical connection (not connected)
Physical connection (connected)
Device icon, e.g. SAFEZONE
Icon Meaning of the icon
Show/hide type code
Show/hide configuration CRC (check sum)
Show/hide user group
Show/hide online state