Titus FlowBar IOM - Manual (Page 5)

5 Installation Manual - FlowBar
FlowBar IOM
Redefine your comfort zone. ™ | www.titus-hvac.com
STEP 4. Attach Diffuser to Ceiling Frame
̷ Lift the FlowBar Diffuser into the framed opening and secure the
Mounting Clips to the frame with flat head screws as shown in
Figure 4.
̷ If multiple sections of FlowBar are required, repeat previous step by
lifting additional sections into the framed opening. Be sure to insert
Spline Support Clips-SS1 into the FlowBar ends to insure a tight and
aligned connection as shown in Figure 4.
̷ Install and secure end caps and mitered corners if required as
shown in Figure 5.
Last edited by: TVDR
Last edited: 06-18-99
FlowBar Connects
STEP 5. Attach Plenum to Diffuser
̷ If Plenums were mounted earlier, attach the Plenum by
snapping it to the Diffuser using the clips on the Plenum as
shown in Figure 6.
̷ If Plenums were not mounted earlier, lift the Plenums into place
and attach them to the FlowBar at this time.
̷ Plenums may need support with ceiling wire to the building
structure per code requirements.
PLENUM CLIPS
FLOWTEE DIFFUSER
PLENUM
UPPER HANGER
CLIP
HANGAR WIRE
FlowBar Installed During Hard Ceiling Installation
END CAPS
SPLINE SUPPORT CLIP
MITERED CORNER
FRAME
FRAME
HARD CEILING
CLIP
10” MAXIMUM
CENTERS
SPLINE SUPPORT CLIP
SS1
MOUNTING
SCREWS
Figure 5. Installation of End Caps & Mitered Corner
Figure 6. Attachment of Plenum to Diffuser
Figure 4. Installation of Diffuser in Ceiling