Titus FlowBar IOM - Manual (Page 15)

15 Installation Manual - FlowBar
FlowBar IOM
Redefine your comfort zone. ™ | www.titus-hvac.com
FlowBar Parts List
Last edited: 10-3-94
Last edited by:
(749a)
Last edited by:
Last edited: 10-3-94
(750a)
Last edited by:
Last edited: 10-3-94
(751A)
Last edited: 06-23-99
Last edited by: TVDR
[FlowBar SC1iso]
Model: WC3 Description: Wall Clip
Application: Use with Frame 1 install Diffuser flush against side wall. Insert a clip into the extrusion boss on the
outside of the Diffuser frame. Attach clip to Framing Member with flat head screw. Clips should be spaced at 10”
intervals.
Quantity per Bag:
28 pieces
Model: WC4 Description: Wall Clip
Application: Use with Frame 6 or 7 install Diffuser flush against side wall. Insert a clip into the extrusion boss on
the outside of the Diffuser frame. Attach clip to Framing Member with flat head screw. Clips should be spaced at
10” intervals.
Quantity per Bag: 28 pieces
Model: SS1 Description: Spline Support Clip
Application: Used to connect multiple sections of FlowBar Diffusers. Insert clip half way into the extrusion boss on
the outside of the Diffuser frame, then slide exposed end of Spline Support Clip into connecting piece of FlowBar.
Quantity per Bag: 28 pieces
Model: SS1 Description: Spline Support Clip
Application: Spline Support Clip can also be used to connect FlowBar Diffuser to Accoustical Ceiling T-bar. Bend
straight clip 90°. Insert clip half way into the extrusion boss on the outside of the Diffuser frame, then slide ex-
posed end of Spline Support Clip into T-bar.
Quantity per Bag: 28 pieces
Model: SC1 Description: ModuFlow Support Clip
Application: Use with ModuFlow Border Type 13 to install in Bolt-Slot Ceiling System. Insert a clip into the extru-
sion boss on the outside of the Diffuser Frame 1. Thread Hanger Wire through hole in clip. Bottom of support clip
rests on bolt slot ceiling bar.
Quantity per Bag:
28 pieces
Model: CFB-10, -15, -20, -25, -30 Description: Concealed Fastener Bracket Kit
Application: Use with FlowBar Border Type 77 to install FlowBar Diffuser after hard ceiling installation. Place
Mounting Bracket above Diffuser. Drill hole into existing FlowBar Spacer(s). Thread #10 x 2 1/2 flat head screw
through each Spacer and into Mounting Bracket. Tighten screw(s) until Diffuser Flanges draw tight against ceiling.
Note: One-Slot models use one screw. Two-Slot models use two screws.
Quantity per Bag: 4 pieces (includes four #10 x 2 1/2 screws for One-Slot models)
4 pieces (includes eight #10 x 2 1/2 screws for One-Slot models)
Last edited: 10-3-94
(746a)
Last edited by: