Titus FlowBar IOM - Manual (Page 10)

10 Installation Manual - FlowBar
FlowBar IOM
Redefine your comfort zone. ™ | www.titus-hvac.com
Field Cutting Linear FlowBar
STEP 1. Prepare Diffuser for Cutting
̷ Working from a table covered with indoor/outdoor carpet, measure
the length of Diffuser to be cut.
̷ Slide the top Spacer sufficiently to allow for removal of the Pattern
Controller(s) as shown in Figure 16.
̷ Remove the Pattern Controller(s) as shown in Figure 17.
̷ Slide both top and bottom Spacers back into the FlowBar frame as
shown in Figure 18, beyond the cut mark to clear the saw blade.
STEP 2. Cut Diffuser to Length
̷ Secure FlowBar to table. Cut through both FlowBar rails with the
finished flanges facing up as shown in Figure 19.
̷ A 10” miter saw with an aluminum cutting blade is recommended.
̷ Caution: Use/Wear proper safety equipment.
̷ Cut the pattern controller so it will fit between the spacers.
STEP 3. Reassemble Diffuser
̷ Move both Spacers to the end of FlowBar.
̷ Slide the top Spacer sufficiently to allow for replacement of the
Cattern Controller(s).
̷ Reinstall the Pattern Controller(s) and slide the top Spacer back over
the Pattern Controller(s).
̷ Lubricate the portion of the Pattern Controller that fits between the
top and bottom spreader with WD-40 or other lubricants of your
choice.
̷ All FlowBar components may be reused after cutting, however,
additional Spacer Kits are an available option.
[FBIP10]
Flanges facing up
Figure 16. Diffuser Spacer Removal
Figure 17. Removal of Pattern Controller
Figure 18. Replacement of Diffuser Spreader
Figure 19. Field Cutting Diffuser