Titus FlowBar IOM - Manual (Page 13)

13 Installation Manual - FlowBar
FlowBar IOM
Redefine your comfort zone. ™ | www.titus-hvac.com
ModuFlow Installation
STEP 2. Install Hanger Clips
̷ Install the Upper Support Hanger (USH) Clips at the clip access
area into the upper boss of the Diffuser extrusion and move a clip
towards each corner as shown in Figure 25.
̷ Additionally for 9/16” bolt slot grids, install the SC1 Clips into the
lower extrusion boss at the access area and move a clip towards
each corner.
STEP 3. Install Diffuser in Ceiling
̷ Install ModuFlow unit into ceiling grid. Moduflow Diffusers lay into
the Acoustical Ceiling Suspension System.
̷ Support Diffuser by attaching Hanger Wire from the clips to the
ceiling structure.
̷ Attach Inlet Duct to the Inlet Collar on the back pan using prescribed
methods.
[FlowBar Moduflow]
Last edited by: TVDR
Last edited: 4-27-99
Last edited by: TVDR
Last edited: 06-23-99
[FlowBar USHiso]
Last edited: 06-23-99
Last edited by: TVDR
[FlowBar SC1iso]
USH Clip SC1 Clip
Last edited by: TVDR
Last edited: 06-23-99
[FlowBar USHiso]
Last edited by: TVDR Last edited: 06-23-99
[FlowBar USHiso]
Last edited by: TVDR Last edited: 06-23-99
[FlowBar USHiso]
Hanger Wire
USH Clip
Clip Access Area
Figure 25. Installation of USH clips
Figure 26. View of USH and SCI Clips