STEMCO HandBAT RF - Manual (Page 5)

5/29/2012 Page 5
If you have an AirBAT sensor, use the up/down keys to highlight Active AirBAT from the Select
Device screen.
Point the HandBAT at the AirBAT sensor you wish to read.
Press the Enter Key.
If the sensor is not within range or there is a problem with the sensor you will get the Read Failed
screen as shown earlier in this manual. Use the HandBAT help screens to diagnose the difficulty.
When a successful read of the AirBAT has taken place, the following screen will appear on the
HandBAT. This screen is the main information screen for the AirBAT sensor. The data is now
stored in the hand held reader for later viewing.
To change the pressure warning limits on the sensor press the right ( → ) arrow key.
A screen similar to the one shown below will be displayed.
Select Change Low Limit
Press Enter