STEMCO HandBAT RF - Manual (Page 6)

5/29/2012 Page 6
If you want to change the limits
Use the arrow keys to navigate to the setting you want to change
Press the Enter Key and you will be allowed to change the limits in 5 PSI increments by
pressing the up ( ↑ ) or down ( ↓ ) arrow keys.
When the limits have been set to the desired values press the Enter Key which changes
the default write settings
Then arrow to the Write Limits line
Press Enter.
This will write the limits to the desired tag. The writing screen will appear as follows.
You will be returned to the previous screen with a notification of whether or not the write was
successful. If the write to the AirBAT sensor works a screen similar to the one shown below will
be displayed. The new limits should be shown on the screen.
If the write failed, a screen similar to the following will appear with the failed message.
If you should get the Write Failed message: