STEMCO HandBAT RF User Manual
Page 15
5/29/2012
Page 15
3.) The device should be considered a spread spectrum transmitter.
4.) Typical exposure times are less than 5 seconds during any tag reading.
5.) This device is tested and evaluated under US FCC part 15 section 247.
6.) The device is tested as a production unit.
The unit uses a meander line radiator with less than 3 dBi of gain and less than 10 mW of output
power.
See also other documents in the category STEMCO For the car:
- Voyager and Discover (1 page)
- Guardian and Guardian HP(TQM) (1 page)
- Standard and Grit Guard HP(TQM) (1 page)
- Pinion Seal (1 page)
- Pro-Torq (2 pages)
- 610-0024 Hubodometer Bracke (1 page)
- 610-0011 Hubodometer (1 page)
- Dual Tire AirBAT RF (2 pages)
- AirBAT RF Single Tire (2 pages)
- AirBAT SST RF (2 pages)
- AirBAT DAS (1 page)
- Tractor Interface Module (20 pages)
- 821-7000 BatRF Tractor Interface Module (9 pages)
- 821-7002 BatRF Tractor Interface Module - Switch Input (TIM-SI) (7 pages)
- Serial Number Recording Form For BatRF/SkyBitz (1 page)
- DataTrac PRO (2 pages)
- DataTrac Vibration Isolation Bracket (1 page)
- TracBAT Pro (2 pages)
- Aeris (42 pages)
- Aeris Pre-Prep Axle (2 pages)
- Aeris SmartSense Upgrade Kit (3 pages)
- Aeris Inflation System Troubleshooting (18 pages)
- Moisture Ejector (2 pages)
- Moisture Ejector (1 page)
- Qwik Kit King Pin Repairs (1 page)
- Plus Kit King Pin Repairs (1 page)
- Qwik Kit King Pin Spindle Conversion Ford and Mack (1 page)
- Top Kick Kodiak (1 page)
- Mack Volvo fxl (2 pages)
- Kit 50034 (2 pages)
- Spring Pin (1 page)
- Qwik Kit King Pin (2 pages)
- Axle Pro (24 pages)
- 84.056.07 Axle Pro (2 pages)
- 84.103.19 Axle Pro (2 pages)
- Qwik Kit Mack and Volvo King Pin (2 pages)
- Qwik Kit Bushing (1 page)