STEMCO HandBAT RF - Manual (Page 12)

5/29/2012 Page 12
Configure – Version
When Version is selected the following screen will be shown. This screen will normally only be
referenced for warranty or upgrade purposes.
The version screen allows the user to tell which version and build numbers are currently
programmed into the processors inside the unit.
Configure – HandBAT settings
The HandBAT settings screen allows you to set default parameters in the system.
When selected a screen similar to the one below will be displayed.
Selecting the Coolant Units option allows the user to select the desired measurement
type for coolant entry units that will be used when entering coolant amounts (i.e. Qt, Lit,
or Gal.).
Selecting the Fuel Units option allows the user to select the desired measurement type
for fuel quantities to be used when entering fuel amounts (i.e. Lit or Gal).
The Set Low Limit option is the low tire pressure setting that will be used as a default but
can be overridden when actually writing the low limits in an AirBAT.