Skyjacker HB-TU760MS User Manual
Page 7
I-TU746SP
Pg 7
20.
6" Lift: Install the new Skyjacker aluminum coil spring spacer on the
top of each OEM strut isolator pad. (See Photo # 24)
21.
6" Lift: Install the OEM upper strut mount, aligning the marks made in
Step # 19. Tighten the retaining nut & uncompress the OEM coil
spring. (See Photo # 25)
22. Install the new Skyjacker strut spacer on the top of each OEM strut
assembly using the OEM hardware. (See Photo # 26)
23. Install the strut / spacer assemblies by aligning the upper strut mount
studs with the OEM mounting locations using the supplied 10mm
nuts. (See Photo # 27)
24. Install the new Skyjacker bump stop brackets using the supplied
10mm x 25mm bolts. (See Photo # 28) Attach the OEM bump stops
to the new bump stop brackets using the supplied 10mm nuts.
Note: The new bump stop brackets are side specific for passenger &
driver side. (See Photo # 29)
25. Reinstall the OEM lower control arms to
both the driver & passenger sides.
Reinstall the OEM lower strut mounts to
the OEM lower control arms.
26.
4Wd Models: Connect the OEM
cv-axles. (See Photo # 30) Attach the
new Skyjacker steering knuckles to the
upper & lower OEM control arms using
the OEM hardware.
27. Attach the OEM ABS lines to the OEM
upper control arms & relocate the OEM
ABS lines to the new Skyjacker steering
knuckles.
28.
4Wd Models: Install the OEM cv-shaft
nuts to the center of the OEM hub
assemblies (See Photo # 31)
Photo # 25
Photo # 26
Photo # 27
Photo # 28
Photo # 29
Photo # 30
Photo # 31
Photo # 24