Skyjacker FA650 - Manual

Installation:
1. Park the vehicle on level ground, set the emergency brake, &
block the rear tires / wheels.
2. Remove the OEM drag link assembly from the pitman arm.
Loosen the pitman arm nut from the steering sector using a
1 13/16” socket. (See Photo # 1) Using a pitman arm puller,
remove the pitman arm from the sector. (See Photo # 2)
3. Note: Before installing the new Skyjacker pitman arm, it is
extremely important that the following steps be followed. The
dri-lock compound on the threads of the OEM nut & the threads
on the steering sector shaft must be thoroughly cleaned off &
the threads dried before applying thread locking compound.
4. Using the supplied thread locking compound, apply a heavy bead
all the way around the entire threads of the nut. (See Photo # 3)
Once the thread locking compound has been applied, install the
new Skyjacker pitman arm & OEM nut. Torque to 350 Ft. Lbs.
(See Photo # 4)
5. Reattach the OEM drag link assembly.
Seat Belts Save Lives, Please Wear Your Seat Belt.
2005 - 2011 Ford Super Duty
Pitman Arm
Installation Instructions
Part # FA450 / FA650
I-FA450 REV1 3-11 Pg 1
www.skyjacker.com
Photo #1
Photo #2
Photo #3
Photo #4