Skyjacker 1088H User Manual
Seat belts save lives, please wear your seat belt
1. Perform pre-alignment checks in a normal manner. Hook-up alignment gauges & record readings.
2. Support the vehicle by the lower control arms.
3. Remove ONE upper control arm bolt at a time.
Note: Remove the OEM welded washer & escess
weld. It may be necessary to elongate the hole in the upper control arm. Clean the surface area
from the cam contacts of any body sealant or weld slag. The cam must operate on a smooth
surface.
4. Install the cam, lock washer, & nut. Snug up the nut, but leave loose enough to allow for
adjustment.
5. Replace the tire / wheel & alignment equipment.
6. Adjust the cams to the needed camber & torque the nuts to 80-100 ft. lbs., while holding the bolt
head with a wrench.
7. Check all readings & adjust as necessary.
Seat Belts Save Lives, Please Wear Your Seat Belt.
I-1088H REV1 3-11
Pg 1
1988-1998 1500/2500
IFS GM 4x4
Eccentric Cam Kit
Part # 1088H
www.skyjacker.com