Skyjacker DA602 User Manual
Skyjacker For the car
1994 - 2011 DoDge 1500 - 3500
4WD
Pitman arm
Part # Da300, Da302, Da303,
Da309, Da600, & Da602
1. Remove the drag link from the pitman arm & lower it down. (See Photo # 1)
2. Remove the pitman arm from the steering sector.
note: A pitman arm puller will be required. (See
Photo # 2). Install the new Skyjacker® drop pitman arm using the OEM hardware & torque to the OEM
specs. Completely remove the OEM stabilizer.
note: The OEM stabilizer cannot be reinstalled when
using a drop pitman arm, but a replacement one is available from skyjacker®). Refer to a Skyjacker
catalog for make & model part #'s.
3. Loosen the turn buckle clamps on the drag link, rotate 180°, & install in the bottom end of the new
pitman arm. (See Photo # 3) Tighten to the OEM specs (be sure to install cotter key). Tighten the turn
buckle with the clamps & bolts rotated to the top side of drag link to provide clearance for the steering
stabilizer boot.
Photo # 1
Photo # 2
Photo # 3
I-DA300-309 REV1 3-11
Pg 1
www.skyjacker.com