Skyjacker HB-TU760MS - Manual (Page 5)

8. Place a jack under the OEM control arms for support & disconnect
the OEM lower control arms. Disconnect the OEM lower strut
mounts & remove.
9. 4Wd Models: Support the front differential with a transmission jack.
(See Photo # 8)
10. 4Wd Models: Remove the OEM front differential mounting bolts &
remove the OEM front differential brackets. (See Photo # 9)
11. 4Wd Models: It will be necessary to cut the OEM rear cross
member with a reciprocating saw. The driver side will need to be cut
for front drive shaft clearance. The measurement is 3 3/8” from the
inside of the frame rail. (See Photo # 10)
12. 4Wd Models: It will be necessary to cut the passenger side OEM
rear cross member 2 1/2” from the OEM
lower control arm mount. (See Photo
# 11) Note: It will be necessary to grind
down this area after cutting for the new
Skyjacker cross member caps to be
welded in place. (See Photos # 12 &
# 13)
13. The OEM alignment cam brackets
(alignment ears) will need to be ground
down for the installation of the new
Skyjacker cross members. This will have
to be done on the front side of both front
& rear OEM lower control arm mounts.
(See Photo # 14)
14. Install the new Skyjacker front cross
member using the supplied 24MM x
50MM bolts, washers, & nuts. Note: Do
not tighten the hardware completely at
this time.
The new
front cross
member
should be
installed
with the bolt
flanges on
the front
side of the
OEM cross
member
flanges. (See Photo # 15)
Photo # 8
Photo # 9
I-TU746SP
Photo # 10
Pg 5
Photo # 11
Photo # 12
Photo # 14
Photo # 13
Photo # 15
Front of Vehicle