Sensaphone CELL682 - Manual (Page 64)

62
Cell682 User’s Manual
aLarm aCKNoWLedGmeNT—aLpHaNUmerIC paGer
When sending an alarm message to an Alphanumeric pager, the Cell682 leaves
a text message on the display of the pager. If you have a two-way alphanumeric
pager you can acknowledge the alarm by replying to the original message with
the alarm acknowledgement code. For example, if the acknowledgement code
was 1503, you would simply reply back with “1503.” If you do not have a two-
way pager then you can send the Cell682 an e-mail using either a computer or a
cell phone. The e-mail address of your Cell682 is [email protected], where you
would substitute the word PIN with your PIN number. In the message area sim-
ply send the unit the alarm acknowledgement code.
alarM acknowledgMent—teXt Message to cell phone
When sending an alarm message to a cell phone the Cell682 leaves a text mes-
sage on the display of the phone. You can acknowledge the alarm by sending
an email reply back to the Cell682 with the alarm acknowledgement code. For
example, if your alarm acknowledgement code was 1107, you would simply reply
back with “1107.” Alternatively you can send the Cell682 an e-mail using a com-
puter. The e-mail address of your Cell682 is [email protected], where you would
substitute the word PIN with your PIN number. In the message area simply send
the alarm acknowledgement code.
aLarm aCKNoWLedGmeNT—aUTomaTIC
The Cell682 will acknowledge an alarm itself (automatically) if all of the destina-
tions have been contacted and no acknowledgement was received.
part two: statUs reqUest
You can request a status report from your Cell682 by sending it a command via
e-mail. When the unit receives the command it will assemble a status report and
send it back to the originating e-mail address. Only inputs that are enabled will
be included in the report. If alarm monitoring is not enabled for a particular
input, its status will be displayed as disabled. To request the status report you
need the unit’s password and PIN. The e-mail format to request a status report is
shown below:
To: PIN@cell682.com {replace PIN with your unit’s PIN number}
Subject:
Message:
p password {replace password with your unit’s password}
gst