Sensaphone CELL682 - Manual (Page 53)

51
Chapter 8: alarm notification
To acknowledge the alarm your must press 1 on a touch-tone telephone when
prompted. The system will reply with “alarm acknowledged” when it receives
your acknowledgment. The message will be repeated 3 times so you have
3 chances to acknowledge the alarm during the call. If the the alarm is not
acknowledged the system will hang up, wait a few minutes, and then call again.
The system will call up to 3 times per telephone number.
internet e-Mail
The Cell682 can send alarm messages to internet e-mail addresses. The alarm
message will comprise information from within your Cell682 including the pro-
grammed Unit Name, and Input Name. To program an e-mail destination, click
on the Alarm Notification tab.
Figure 3: Alarm Notification
This screen provides a list of the programmed alarm destinations. To program
or change a destination’s information, click on the name of the person to edit
(or select unused for a new entry) and then click the Edit button. The Edit
Destination screen will appear:
Figure 4: Destination Edit for E-mail
Enter the name for this destination (up to 14 characters) and in the Type field
select Internet E-mail. In the To: field enter the e-mail address (up to 34 charac-
ters).
Warning: Before entering an e-mail address into the Cell682, be sure to test the
address first, using your computer and standard email software. Verify that the
address is working and that the message is delivered.