Sensaphone WSG30 System Users manual - Manual (Page 8)

WSG30 Users Manual
8
ChAptER 1: iNtRodUCtioN
Congratulations on your purchase of the Sensaphone WSG30. This device can work with up to 30
Wireless sensors to monitor Temperature, Humidity, Water on the floor, Power, Dry Contacts, and
4-20mA signals. The sensors use mesh networking technology to create multiple communication paths
between the sensors and the WSG30 to ensure reliable communications. Sensors can also be battery
powered for those installations where an outlet may not be available. A LCD is provided to show the
status of all Wireless sensors. The unit is powered by a plug-in adapter and has a rechargeable backup
battery located inside the enclosure. Circuitry in the unit will maintain precise charging of the battery
system.
The unit comes in a rugged plastic enclosure with tabs for wall mounting. Connections for an antenna,
power supply, and Ethernet are easily accessible from the top and bottom of the unit.
FEAtURES
The Sensaphone WSG30 includes the following features:
• Communicates with up to 30 Wireless Sensors
• Monitors its own power supply and battery
• 80 Character lighted LCD
• Built-in rechargeable battery backup
• Rugged plastic enclosure
tEChnICal suppoRt
Reading this instruction manual will help you install and program the WSG30. Programming and
sensor configuration are performed using the WSG30 web page. Some programming can also be
accessed via the keypad and display.
If there are any questions or problems that arise upon installation or operation, please contact Technical
Support at:
SENSAPHONE
901 Tryens Road
Aston, PA 19014
Toll Free: 1-877-373-2700
Fax: 1-610-558-0222
[email protected]