Sensaphone WSG30 System Users manual - Manual (Page 10)

WSG30 Users Manual
10
RJ-45 10/100BasE-t EthERnEt poRt
This jack is for connecting to your network. Two LEDs indicate Link Status (green) and Receive Data
status (yellow).
powER JaCk
Attach the 9VDC power supply to the power jack. The device will power up as soon as power is applied.
BaCkup BattERy
The device contains a built-in 6V 1.3AH rechargeable battery. The system will monitor the condition
of the battery and an alarm can be initiated if the battery gets low. The system will automatically switch
over to battery power if main power fails.
iNStALLAtioN
This section provides information on:
- Operating environment
- Wall installation
- Replacing the battery
paRts REquIREd
CAT5 Ethernet cable
Screwdriver
Screws and drywall anchors
opERatIng EnvIRonmEnt
Before you install the WSG30 be sure that your operating environment meets the physical requirements
of the equipment.
Operating Temperature: 32º to 122ºF (0º–50º C)
Humidity: 5–90 %RH, non-condensing
Power: 120VAC 60 Hz outlet within 6’ of the installation site
Ethernet: 10/100 ethernet jack nearby
It is recommended that you install the unit in a central location such that the unit has as short a path as
possible to all of the Wireless sensors.
wall mount InstallatIon
The WSG30 can be wall mounted using (4) #6 screws. Drywall anchors may be used if necessary. Follow
the steps below:
1) Hold the enclosure up to the wall and mark the location of either the 2 keyholes or the 4 mounting
holes with a pencil.
2) Drill the holes and insert the drywall anchors (if necessary). Attach the enclosure to the wall with the
screws.
3) Attach the Ethernet cable and plug the power supply to a 120VAC 60Hz outlet.