Robustel M1000 Pro V2 User Guide - Manual (Page 42)

Robustel GoRugged M1000 Pro V2 User Guide
RT_UG_M1000 Pro V2_v.2.0.0
19.11.2013 41 / 69
Confidential
Connection 2 @
Master Mode
enable Connection 2.
Enter the remote Modbus slave IDs here which is corresponding to
“Connection 2”.
Slave ID Range of
Connection
3 @
Master Mode
Available when enable Modbus Gateway, select Master mode and
enable Connection 3.
Enter the remote Modbus slave IDs here which is corresponding to
“Connection 3”.
0-0
Connection 2
Tick this checkbox to enable the second TCP connection to the remote
TCP server. This TCP connection is usually used to connect to the
second Modbus slave gateway.
User need to enter the TCP server’s IP and port here.
Serial data come from Master device to M1000 Pro V2 will be sent to
different TCP server’s IP address according to the Slave ID.
Disable
Connection 3
Tick this checkbox to enable the third TCP connection to the remote
TCP server. This TCP connection is usually used to connect to the third
Modbus slave gateway.
User need to enter the TCP server’s IP and port here.
Serial data come from Master device to M1000 Pro V2 will be sent to
different TCP server’s IP address according to the Slave ID.
Disable
Note: Connection 2 and Connection 3 only can work under TCP client mode, cannot be configured.
3.2.15 Advanced
This tab allows user to set advanced settings after TCP connection is established. Whether need to set this
tab is depend on user’s application requirement.