Robustel M1000 Pro V2 User Guide - Manual (Page 38)

Robustel GoRugged M1000 Pro V2 User Guide
RT_UG_M1000 Pro V2_v.2.0.0
19.11.2013 37 / 69
Confidential
call.
Enable SMS Reply @
Call
Tick Enable to allow gateway send reply short message after
automatically connects to GPRS/UMTS by Call Wakeup from specified
Caller ID (e.g. GPRS on ok!).
Note: Only support text format SMS.
Disable
SMS
Tick the SMS checkbox to allow gateway automatic connects to
GPRS/UMTS with incoming specified short message from specified
Caller ID (phone number).
Specified short message is set at Password item. (e.g. GPRS on)
Disable
Phone Group @ SMS
Set the Phone Group which was allowed to wake up the gateway by
SMS.
1
Password The specified short message which was used to wake up the gateway Null
Enable SMS Reply@
SMS
Tick Enable SMS Reply to allow gateway to send reply short message
after automatic connects to GPRS/UMTS by SMS Wakeup from
specified Caller ID (e.g. GPRS on ok!).
Note: Only support text format SMS.
Disable
Serial Data
Tick Enable to allow gateway automatic connects to GPRS/UMTS from
idle mode when there is data (any data) come out from serial port.
After gateway has connected to GPRS/UMTS and established TCP
connection, the “triggered” data will be sent to destination site.
Enable
Output (Hex) to
COM after online
No matter the gateway is set into “Always Online” mode or “Connect
On Demand” mode gateway will output a massage with this
configured string format data to gateway serial port when it has been
triggered to establish PPP connection (dial up).
Maximum 30 bytes.
Note: Note: If need to output a hex format massage, user need to add
“\x” in front of the massage.
Disable
Note:
1. Time format for Time reboot is 24-hours.
2. The phone numbers for Call and SMS function can be set in Phone Book tab.
3. The Caller ID is required to be written in international format, starting with “+” followed by the country code.