Robustel M1000 Pro V2 User Guide - Manual (Page 15)

Robustel GoRugged M1000 Pro V2 User Guide
RT_UG_M1000 Pro V2_v.2.0.0
19.11.2013 14 / 69
Confidential
RSSI LEDs
Function
None No signal or SIM card not installed properly
1 bar (Only the first LED is on) Weak or insufficient signal (SMS only)
2 bars (The first and the second LED are on) Average signal (GSM/GPRS/UMTS connections)
3 bars (All the RSSI LEDs are on) Exceptional signal (GSM/GPRS/UMTS connections)
The first and the second LED are blinking every 1 second PIN code error
The third LED is blinking every 1 second PIN code error and need to use PUK code to unlock it
The second LED is blinking every 1 second No SIM card or SIM card not installed properly
The third LED is blinking every 1 seconds
Wireless module communication error, no AT
command response.
The first and the third LED are blinking every 1 second Cannot register to network or SIM card is unavailable
2.3 PIN assignment
2.4 Install SIM Card
Be sure to insert a SIM card before you use the gateway.
Note: A SIM card set with PIN code cannot be used normally in the gateway without the correct PIN code.
Make sure to disconnect the adapter and switch off your gateway before inserting or removing your SIM/USIM card.
DB9 Female Connector
PIN RS232 RS485 (2-wire) Direction
1 Data+ (A) -
2 RXD M1000 Pro V2

Device
3 TXD Device

M1000 Pro V2
4 -
5 GND -
6 Data- (B) -
7 RTS Device

M1000 Pro V2
8 CTS M1000 Pro V2

Device
9 -