Robustel R3000 User Guide User Manual
Page 68
Robustel GoRugged R3000 User Guide
RT_UG_R3000_v.2.0.0 17.01.2014 67 / 131
Confidential
RIP @ IP Routing
Item
Description
Default
RIP
RIP (Routing Information Protocol) is awhich
employs the as a routing metric. RIP prevents routing loops by
implementing a limit on the number of hops allowed in a path from the source to
a destination.
Null
Enable RIP Protocol
Setting
Tick to enable RIP function.
Disable
RIP Protocol Version
Select from “RIPv1” and “RIPv2”.
RIPv1
Neighbor IP
If you input this neighbor IP, router will only send RIP request massage to this IP
instead of broadcast. This item only needs to be set in some unicast network.
0.0.0.0
Update times
Defines the interval between routing updates.
30
Timeout
Defines the route aging time. If no update for a route is received after the aging
time elapses, the metric of the route is set to 16 in the routing table.
180
Garbage
Defines the interval from when the metric of a route becomes 16 to when it is
deleted from the routing table. During the Garbage-Collect timer length, RIP
advertises the route with the routing metric set to 16. If no update is announced
for that route after the Garbage-Collect timer expires, the route will be deleted
from the routing table.
120
Enable Advance
Tick to enable RIP protocol Advance Setting.
Disable
Default Metric
This value is used for redistributed routes.
1
Distance
The first criterion that a router uses to determine which routing protocol to use if
two protocols provide route information for the same destination.
120
Passive
Select from “None”, “Eth0”, “Eth1” and “Default”.
None